Job Description:
Candidates must send resume at resume2013@gc-employment.com with the title "Tool & Die Maker (Concord) (Dufferin & Langstaff)"and then register with us at http://www.gc-employment.com/jobsearch/index.php?option=com_catsuser&view=register
Scope:
This position covers duties and responsibilities of the Toolmaker.
Reporting To:
Reports directly to Press Supervisor.
Safety equipment requirements:
The wearing of appropriate safety equipment as described below is a condition of employment, not one of choice. Safety equipment that must be worn while at duty is: Standard Protective Equipment
Major duties and responsibilities:
•Responsible for conducting tooling service and setups.
•Repair and maintain tools and dies as assigned.
•Trouble shooting and repair dies in press.
•Reviews and completes tool service reports.
•Review tooling at the end of a production run and determine die status.
•Work in a safe manner at all times.
•Adopt and practice Kaizen Principles and Concepts.
•Participate in Kaizen and GEAR activities.
•Follow all general procedures where applicable as indicated in the GENERAL PROCEDURES section of the level III Procedure manual.
• Follow all DEPARTMENTAL GENERAL PROCEDURES as well as procedures for this position as indicated in the level III Procedure manual.
•Perform other duties as assigned.
•Work in compliance and conform to QS9000, TS16949 and ISO14001 standards
Experience and skills required:
•Minimum five (8 ) years experience in Heavy stamping/blanking/forming and/or fine blanking
•Fine blanking experience would be an asset
•Good communication skills including ability to read, write and speak English pertaining to drawings and/or blueprints.
•Must have experience in a press shop environment.
•Must have trouble shooting experience.
Shift and Salary:
Afternoon: 3pm -11pm
25/hr